The Monforts 70 mm high guide rail (1 m) has a section height of 70 mm and a section length of 1 m. It is installed on both sides of the oven, supports the clips and chain and defines their travel path. Over its span the rail carries the combined weight of the chain and clip assemblies and operates continuously at high temperature. A profile with a larger section height offers higher bending stiffness, which helps limit sagging and bending and suits positions with greater load or stricter straightness requirements. The rail is intended for Monforts-series stenter frames and is used for new machine assembly or for replacing bent or worn rails. The height of the existing rail should be checked against 70 mm. Material and other section dimensions are subject to the physical part.
1. Section height: a 70 mm high section with relatⅣely high bending stiffness.
2. Load bearing and guidance: carries the clips and chain as a whole and defines their travel path.
3. Deformation resistance: the high-section profile helps reduce sagging under long-term heat and load.
4. Standard length: each section is 1 m, which facilitates sectional installation and partial replacement.
5. Machine correspondence: applicable to the rail positions of Monforts-series stenter frames.
6. Customization: specifications such as height and length can be produced under OEM/ODM according to drawings, with requirements to be negotiated separately.
|
Part: |
70 mm high guide rail |
|
Section height: |
70 |
|
Length: |
1M |
|
Series/Applicable machine: |
Monforts-type stenter |
|
Process: |
Stentering, drying, heat setting |