The Monforts overhead wide guide rail, middle rail (1 m, left) is intended for Monforts-series stenter frames and is a middle-section rail installed on the left side of the machine. Each section is 1 m long, and left-hand and right-hand versions must not be mixed. In an overhead system the rail is suspended and fixed from above instead of resting on lower supports, and the wide rail surface increases the supporting area for the chain, which helps reduce lateral swing during chain travel. The middle rail is located in the central part of the complete track, and both ends are connected to adjacent sections through joints. Polished rail surfaces, loose suspension points or a sagging track call for inspection and replacement. Material and specific dimensions such as width are subject to the physical part or drawing.
1. Overhead installation: suspended and fixed from above, applicable to overhead guide rail systems.
2. Wide rail surface: a larger supporting area helps reduce chain swing.
3. Left-hand configuration: used only on the left side of the machine and not interchangeable with right-hand rails.
4. Middle section position: both ends are connected to adjacent sections through joints, with a section length of 1 m.
5. Inspection items: polished rail surfaces, loose suspension points and track sagging are the principal checks.
6. Machine compatibility: corresponds to Monforts-series stenter frames.
7. Customization capability: OEM/ODM according to drawings or samples is available, with specifications subject to negotiation.
|
Part: |
Overhead wide guide rail, middle rail |
|
Length: |
1M |
|
Position: |
Left |
|
Series/Applicable machine: |
Monforts-type stenter |
|
Process: |
Stentering, drying, heat setting |