The Santex pin plate (plated) is mounted on the chain of Santex stenter frames. One face carries the pin row, which penetrates the fabric selvedge, and the other face is fixed to the chain so that selvedge tension is transmitted to the chain links; the plate is therefore the connecting part between selvedge and chain. The plate surface is plated to reduce corrosion and the adhesion of foreign matter. Quality inspection has two points: the pin tips should be sharp and aligned, and the plating should be intact. Rust tends to appear where plating has come off, and detached rust powder leaves yellow stains on the fabric, while blunt pin tips lower the holding force on the selvedge and enlarge the needle holes. After a plate is replaced, the wear condition of the adjacent plates is observed. It is intended for Santex stenter models; pin pitch, pin length and plate length are subject to the physical part or drawing.
1. Double-face functional structure: one face carries pins to hold the selvedge and the other connects to the chain to transmit load.
2. Plated surface: lowers the tendency to corrode and reduces adhesion of foreign matter.
3. Inspectable pin condition: pin tip sharpness and alignment directly reflect holding performance.
4. Contamination control: intact plating avoids rust powder soiling light-colored fabric.
5. Model correspondence: used on Santex stenter frames.
6. Adjacent plate check: wear of neighboring plates is confirmed at replacement.
7. Custom machining: OEM/ODM is supported, with pin row parameters and plating requirements confirmed in the order.
|
Series: |
XTY-570 Santex-type series |
|
Name: |
Pin plate (plated) |
|
Applicable machine: |
Santex vertical stenter |
|
Surface treatment: |
Plated |