The XTY-60 IL Sung short-leg pin plate holder with copper pins is used on IL Sung-type stenter frames and is located between the chain and the pin plate, where it connects and supports. The holder has a short-leg structure and a white polished surface, while the pins are made of copper. Copper is softer than steel, so the pin tips are less likely to break on contact with selvedge layers or hard impurities in the fabric, and the pins suit selvedge holding of fine, dense and elastic fabrics. The wear of copper pin tips is comparatively visible, so the tip condition requires periodic inspection. Short-leg and long-leg specifications differ in mounting height, and leg length and hole spacing should be verified during selection. Specific dimensions are subject to the physical part or drawing.
1. Copper pin configuration: the pins are made of copper, and the tips are less likely to break on contact with hard impurities.
2. Short-leg holder body: the small leg length corresponds to a lower mounting height.
3. White polished surface: the finish aids visual identification and helps resist rust.
4. Suitability for fine and dense fabrics: appropriate for pin holding of the selvedge of fine, dense and elastic fabrics.
5. Inspectable tip wear: copper pin wear is directly visible, so the replacement time can be determined by visual examination.
6. Series affiliation: belongs to the XTY-60 series and fits IL Sung-type equipment.
7. Customization note: OEM/ODM processing according to drawings or samples is available, with pin material, leg length and other requirements negotiated separately.
|
Model: |
XTY-60 |
|
Series: |
XTY-60 stenter parts |
|
Applicable machine: |
IL Sung-type stenter |
|
Type: |
Short-leg pin holder |
|
Pin: |
Copper pin |
|
Finish: |
Polished white |
|
Process: |
Stentering, drying, heat setting |